top of page
Finished Boards
Collaboration Logo
Starting Point
Started with 1 ft x 10 ft and 1.5 ft x 6 ft of rough cut maple
Planed and Joined Lumber
by Max
Ripped into 2 in x 2 in strips on the table saw
First Glue up
2 x 2 inch strips glued together
Final Glue Up
First Glue up was ripped with a cross cut sled and remaining strips were glued together in alternating pattern
Finished Boards
Collaboration Logo
Starting Point
Started with 1 ft x 10 ft and 1.5 ft x 6 ft of rough cut maple
Planed and Joined Lumber
by Max
Ripped into 2 in x 2 in strips on the table saw
First Glue up
2 x 2 inch strips glued together
Final Glue Up
First Glue up was ripped with a cross cut sled and remaining strips were glued together in alternating pattern
Finished Boards
Collaboration Logo
Starting Point
Started with 1 ft x 10 ft and 1.5 ft x 6 ft of rough cut maple
Planed and Joined Lumber
by Max
Ripped into 2 in x 2 in strips on the table saw
First Glue up
2 x 2 inch strips glued together
Final Glue Up
First Glue up was ripped with a cross cut sled and remaining strips were glued together in alternating pattern
Finished Boards
Collaboration Logo
Starting Point
Started with 1 ft x 10 ft and 1.5 ft x 6 ft of rough cut maple
Planed and Joined Lumber
by Max
Ripped into 2 in x 2 in strips on the table saw
First Glue up
2 x 2 inch strips glued together
Final Glue Up
First Glue up was ripped with a cross cut sled and remaining strips were glued together in alternating pattern
Finished Boards
Collaboration Logo
Starting Point
Started with 1 ft x 10 ft and 1.5 ft x 6 ft of rough cut maple
Planed and Joined Lumber
by Max
Ripped into 2 in x 2 in strips on the table saw
First Glue up
2 x 2 inch strips glued together
Final Glue Up
First Glue up was ripped with a cross cut sled and remaining strips were glued together in alternating pattern
Cutting
Boards
Much like baking cookies, when building cutting boards it doesn't make sense to make only one at a time.
WHEN
December 2020 - February 2021
WHAT
-
Planning and Design
-
Gluing
-
Sanding & Finishing
-
Engraving logo and customizations
bottom of page